|
| |
| Adapter Sleeves |
|
Sleeves are used to locate rolling bearings with tapered bore (taper 1:12). Our adapter sleeves are provided with same taper as is available on the bearing inner rings. All sleeves are ground for the taper to have correct seat & are checked for the consistent accuracies. Our adapter sleeves are supplied with lock nut and lock washer suitable for metric shaft sizes in multiple of 5mm as well as inch sizes in multiples of ¼ inches.
|
| • H |
- |
Adapter Sleeves for metric size |
| • HE |
- |
Adapter Sleeves for inch size |
| • OH |
- |
Adapter Sleeves with oil injection groove |
| • AH |
- |
Withdrawal Sleeves for metric size |
| • AOH |
- |
Withdrawal Sleeves with oil injection groove |
| • A |
- |
Thread Standard for whitworth to metric |
|
| |
| Lock Nuts provide simple means of axially locating bearings and other machine components on the shafts and also facilitate mounting and dismounting of small bearing on withdrawal sleeves |
| |
| Lock washers are used to lock the nuts on the shaft, while inner tab is used for locking for the larger size of nuts. |
|
 |
|
|
